Your furnace is an integral part of your home. Without one, you wouldn’t be able to stay warm during cold weather. Yet furnaces can have some issues that are more common than others.

Let’s go over these issues and discuss what they might cost to correct so you know before you contact an HVAC technician. Some of the most common furnace repair issues involve:

  • Furnace won’t turn on
  • Furnace doesn’t stay lit
  • Furnace won’t blow hot air
  • Furnace won’t turn off

1. The Furnace Will Not Turn On

There are a few reasons why your furnace won’t turn on, so make sure to check all of them.

  • Is your thermostat set correctly? Make sure it’s set to “heat,” “auto” and that your desired temperature is higher than the room’s current temperature. If you have a programmable thermostat, make sure it has fresh batteries.
  • Is the circuit breaker tripped? Your furnace can’t operate if it doesn’t have power. Reset the switch if it’s facing the outside of the electrical panel.
  • Is the furnace switch off? Your furnace has a power switch found on or near it. Since this switch looks like a light switch, it’s easy to unintentionally turn it off. If it was off, it might take your furnace a few minutes to turn on.
  • Is the air filter clean? A dusty air filter can cause a lot of issues for your furnace. Replace yours if you can’t see light through it.

Estimated Repair Cost

This issue can be complicated, so the estimated cost to repair it depends on what’s wrong.

2. The Furnace Won’t Stay Lit

Your furnace uses a certain sequence when it starts heating your home.

  1. Your thermostat notices the temperature has fallen and tells your furnace to turn on.
  2. The draft inducer fan activates to bring in fresh air for combustion.
  3. The gas valve unlocks for the burners, which are ignited electronically.
  4. The flame sensor tells your furnace the burners have been ignited.

If something is wrong during the sequence, your furnace will shut down as a preventive measure.

A couple of potential causes for this problem include:

  • Dirty or malfunctioning flame sensor. If the sensor doesn’t sense a flame, it will shut off your furnace to prevent natural gas from spilling into your home. The ignition process corrodes flame sensors as time passes. While cleaning during annual furnace maintenance can help, yours may eventually need to be taken out and changed.
  • Bad limit switch. This safety feature will turn off your furnace if it senses backdrafting. Backdrafting is dangerous, since carbon monoxide and natural gas can leak into your home. These switches can malfunction due to age, damage or dust accumulation.
  • Old thermostat. If your thermostat isn’t working correctly, your furnace won’t be able to operate.
  • Dirty air filter. A dirty air filter can reduce airflow and cause your furnace to shut down to prevent overheating. Make sure to replace yours every 30 to 90 days, or anytime you can’t see light through it.

Estimated Repair Cost

These costs are estimates, so it’s important to note yours may vary based on your furnace’s brand and model.

  • Flame sensor: $350–$500
  • Limit switch: $150–$300
  • Thermostat: $150–$350
  • Furnace filter: $10-$30

3. The Furnace Is Blowing Cold Air

In many instances, this problem is linked to a wrong thermostat setting or a dirty air filter that’s limiting airflow. Follow the steps above to resolve the issue.

4. My Furnace Won’t Turn Off

If it’s extremely chilly outside or you like your home to be toasty, your furnace may be working for a long time.

If this isn’t what’s happening, ensure your thermostat is set correctly and working properly. If your fan setting is at “on,” the blower motor will be running even when the furnace isn’t, so it’ll seem like your furnace is on all the time.

Otherwise, there might be a problem with the blower motor or your ductwork may be leaking air, forcing your furnace to run constantly to make up for the lost air.

Estimated Repair Cost

These costs are approximations, so it’s necessary to note yours may be different based on your furnace’s brand and model.

  • New blower motor: $250–$800
  • Seal ductwork: varies based on square footage

Mountain Air Can Get to the Bottom of Your Furnace Issues Quickly and Affordably

Furnace problems can be a costly headache, but not when you work with Mountain Air. We’ve been delivering the quality, affordable furnace repair Morgantown homeowners have trusted since year. Contact us at 304-413-1287 to receive your free estimate today.